Product: 6 Series/C200 Series Chipset Family 6 port SATA AHCI ControllerĬapabilities: storage msi pm ahci_1. The output of sudo lshw -class storage -class disk follows: *-ide UNCLAIMEDĬapabilities: ide msi pm pciexpress cap_list I am sure it's not a hardware related problem as I have already successfully installed another operating system on the same computer. Switch the SATA mode in the BIOS from IDE to AHCI.I have already tried the following two solutions without any success: Sudo fdisk -l shows only /dev/sda1, the USB drive from which I am running the installation. When I reach the Installation type step, the panel which is supposed to show devices and partitions looks empty. If you have no Linux on the system you will need another option. I am trying to install Ubuntu 11.10 64-bit on it but the installer does not recognize/detect/see the hard drive. With sata set to ahci mode in bios the pc simply wont boot, it gets to the blue windows logo and hangs with the spinning balls endlessly spinning. If so, you can either extract the iso files and copy them to a partition on the drive and put an entry in the menu.lst or grub. I get 0003 when trying to use a physical cd in the cdrom drive, or an ISO file of the CD. So, I get CDROM boot failure code 0003 instead of 0008. Surely I should be able to easily install from a USB in 2016 - half of notebooks these days do not even have CD drives.I have a new computer with a Seagate ST500DM002 SATA internal hard drive. CDROM boot failure code : 0003 Boot from CD-Rom failed FATAL: Could not read the boot disk. This probably means the CD-ROM was not in the drive. 'Your installation CD-ROM couldn't be mounted. UPDATE: I have tried running the installation from the USB as a non graphical install I get the same error. Is there any way to work around this so that I can have a separate caddy SSD with Kali? No CDROM is found since it is a caddy, and so I have to abort the installation. There are a many different possible causes for these problems. Put this on top of your config file if the global configuration is stored in /etc: include /etc/bochsrc Bochs now treats an unknown option as optional device plugin if it exists. The installer may also even after booting successfully from CD-ROM fail to recognize the CD-ROM or return errors while reading from it during the installation. installation defaults in a global config file (e.g. However, less than a minute into the installation process, I am told I need a CDROM to continue installation. Sometimes, especially with older CD-ROM drives, the installer may fail to boot from a CD-ROM. I boot from the USB and choose the option to perform a graphical installation. So I do not have a free CD-ROM drive to install with unless I take out the primary internal drive and this seems like a lot of faffing about to do at 5am when a USB boot would be so much more convenient. The UBCD main menu loads up fine but no CD-ROM drivers are found I get something like the screenshots here: But no 'Unit 0' line (or similar), and when it finishes the autoexec.bat script there's no drive letter assigned for the CD-ROM. This is because I want to continue to have the option to use Windows on this laptop, but I do not want to lose space by creating a partition. I am using a separate SSD installed in a DVD-drive caddy, and I would like to install Kali on this drive. Right?ĮDIT: Kali Linux 64 bit (25cc6d53a8bd8886fcb468eb4fbb4cdfac895c65) ISO used together with Universal-USB-Installer-1.9.6.4 I am unable to install Kali 2016.2 using a USB. The installation then continued without problems. Scan again for the CD-ROM and the USB drive will be recognized. I found a solution: after the installer demands the CD-ROM, take the USB out of the port and then reinsert it.
0 Comments
Leave a Reply. |